电缆槽模具都是用于预制生产，所以需要等待混凝土****凝固在进行拆模，电缆槽模具使用后是否完好，没有问题就清洗干净偷摸一层机油存储到仓库中。

Cable tray molds are all used for prefabricated production, so it is necessary to wait for the concrete to completely solidify before dismantling the molds. After using the cable tray molds, whether they are in good condition, they should be cleaned and a layer of engine oil should be stolen and stored in the warehouse.

使用电缆槽模具进行生产时的操作步骤也十分简单，只需要将电缆槽模具的内膜和外模进行简单的拼接，组装好模具后需要检查内外膜连接处是否留有缝隙

The operation steps when using cable tray molds for production are also very simple. Simply splice the inner and outer molds of the cable tray molds, and after assembling the molds, check if there are any gaps left at the connection between the inner and outer membranes

             

使其紧密连接在刷涂脱模剂，注意脱模剂要均匀的涂抹在模具的内表面，以保证混凝土凝固后可以完整的脱落，放置电缆槽预制件发生掉角的问题。刷图好脱模剂就可以将混凝土注入模具中了

Make it tightly connected by brushing the release agent, and pay attention to the uniform application of the release agent on the inner surface of the mold to ensure that the concrete can completely fall off after solidification, and prevent the problem of falling corners when placing cable tray prefabricated components. After brushing the mold release agent, the concrete can be injected into the mold

注意注入混凝土后还需要使用振动棒在其中均匀搅拌，将混入混凝土的气泡振出，以保证预制件达到足够的硬度，表面不留下蜂巢状的孔洞，影响其密度及美观。

Note that after injecting concrete, it is necessary to use a vibrating rod to mix it evenly and remove the bubbles that have been mixed into the concrete, to ensure that the prefabricated components reach sufficient hardness and do not leave honeycomb shaped holes on the surface, which affects its density and appearance.